SUHFORM / Members

영상 사용가이드 보기 →

Align 사용 범위·주의사항

SUHFORM Align은 치과 전문가를 위한 3차원 스캔 데이터 정합·좌표 정렬 및 후속 CAD 작업용 데이터 준비 소프트웨어입니다. 변환된 모델과 참고 메시를 내보내며, 보철물의 최종 설계와 제작은 별도의 CAD 및 제작 과정에서 수행됩니다.

자동 정합·정렬 결과에는 오류가 포함될 수 있습니다. 사용자는 보철물 설계·제작 등 후속 작업에 사용하기 전에 원본 스캔 데이터와 비교하여 결과의 적합성을 확인하고, 필요한 경우 수정해야 합니다. SUHFORM Align은 임상 진단이나 치료계획을 위한 소프트웨어가 아닙니다.

평균값 교합기 설정으로 생성되는 FGP 참고 메시 등은 사용자가 지정한 매개변수에 따른 기하학적 참고 데이터이며, 개별 환자의 실제 턱운동을 측정하거나 재현한 결과가 아닙니다.

환불은 안내된 환불 정책에 따라 처리됩니다. 고객의 법적 권리와 SUHFORM이 법에 따라 부담하는 책임은 그대로 유지됩니다.

환불 / Refunds · 약관 / Terms

Watch Align tutorials →

Align intended use & precautions

SUHFORM Align is software for dental professionals that supports 3D scan registration, coordinate alignment, and data preparation for subsequent CAD workflows. It exports transformed models and reference meshes. Final restoration design and fabrication are performed using separate CAD software and fabrication processes.

Automated registration and alignment results may contain errors. Before using any output for subsequent work, including restoration design or fabrication, users must compare it with the original scan data, verify its suitability, and make corrections where necessary. SUHFORM Align is not intended for clinical diagnosis or treatment planning.

Reference meshes, including FGP-type meshes generated using average-value articulator settings, are geometric references based on user-defined parameters. They do not measure or reproduce an individual patient’s actual jaw movements.

Refunds follow the published refund policy. Your legal rights and SUHFORM’s responsibilities under applicable law remain unchanged.

환불 / Refunds · 약관 / Terms